68
en | B94x/B93x Actions menu Control Panels
2019.06 | 07 | F.01U.307.371 Bosch Security Systems B.V.
16 B94x/B93x Actions menu
Use the Actions menu to reset sensors, change outputs, see the test
menu, see the RPS menu, go to an area, update system firmware, or to
view service bypassed points.
16.1 Reset
Detection devices, such as smoke detectors and shock sensors, might
require a reset action before they return to normal operation. This
function momentarily removes power from these devices to reset them.
Resetting sensors:
1. Open the Main Menu.
2. Press Actions to open the menu.
3. Press Reset to open the menu.
4. Enter your passcode and press ENTER. The display shows Sensors
resetting for approximately 3 seconds and then goes blank before
returning to idle disarmed text.
If you enter this function and the detector or sensor resets
momentarily, but then returns to a faulted condition, the conditions
causing the activation may still be present or the detector may be
faulty. Check to be certain that there is no smoke, fire, or other danger
present.
If you cannot reset the detector or sensor, contact your security
company.
To Next Page
Loading...
Need help?
General
