Bosch KTS 590 User Manual

1 689 989 223 2016-12-15| Robert Bosch GmbH
| 18 | KTS 560 / 590 (KTS 5a Series) | Device descriptionen
en
3.2 Prerequisites
3.2.1 Hardware
PC/laptop with at least two free USB interfaces.
3.2.2 Operating System
Operating System USB Bluetooth
Win XP (from SP3)/Win Vista/Win 7/
WIN 8/Win 10
x x
3.2.3 Software
In order to operate the KTS module, the current ES-
I[tronic] 2.0 software must be installed and enabled on
the PC/laptop. This is subject to additional cost.
3.3 Scope of delivery
i The scope of delivery depends on the product variant
ordered as well as the special accessories ordered,
and can deviate from the following list.
Designation Order number
Diagnostic device KTS 560
Diagnostic device KTS 590
–
–
Bluetooth USB adapter –
OBD connection cable, 1.5m 1 684 465 755
USB connection cable 3 m 1 684 465 562
Power supply unit 1 687 023 736
Measurement cable blue/yellow 1 684 463 950
Measurement cable red/black (KTS 590) 1 684 463 945
Measuring clamp black
(1x on KTS 560, 2x on KTS 590)
1 681 354 035
Test prods 1 683 050 050
Test prods 1 684 480 125
Protective cap 1 680 591 037
Case 1 685 438 648
DVD1 ESI[tronic]
Diagnosis and technology 1 987 729 601
DVD ESI[tronic] 2.0 1 987 P12 037
Mounting bracket with 3 oval-head screws –
Important information and safety instructions 1 689 979 922
Instruction manuals 1 689 989 223
1 689 989 266
1 689 989 277
! Bosch PC with operating system Win 7, fitted ,e.g.,
in BEA850/950, FSA 740 or FSA 760 in the trol-
ley have to use the USB 3.0 port for the Bluetooth
USB adapter. Exception: On the DCU100 / 130 /
220, the internal Bluetooth hardware can be used.
If a different Bluetooth USB adapter is plugged in,
proper operation of the USB functionality cannot be
guaranteed.
! Use measurement cables for measurements smaller
than 60VDC, 30VAC or 42VACpeak only.
The accessories must only be used in circuits
which are not connected to a mains voltage
supply (measuring category 0 according to
EN 61010-2-030:2010). The enclosed accesso-
ries must only be used with Bosch products,
and at voltages below the voltage value as
imprinted on the accessories. When combin-
ing accessories, it must be ensured that the
lowest voltage value imprinted on the acces-
sories is not exceeded.
! The OBD connection cable (1 684 465 755) included
in the scope of delivery must only be connected to
KTS 560 / 590 and not to any other KTS modules.

Bosch KTS 590 Specifications

General

Brand	Bosch
Model	KTS 590
Category	Control Unit
Language	English