1 689 989 223 2016-12-15| Robert Bosch GmbH
Initial commissioning | KTS 560 / 590 (KTS 5a Series) | 23 |
5. Maintenance
5.1 Cleaning
The housing of
KTS 560 / 590 (KTS 5a Series)
are only
to be cleaned using a soft cloth and a neutral cleaning
agent. Do not use any abrasive cleaning agent or rough
cleaning cloths.
5.2 Maintenance
The tab Customer service can be used for performing
various tests in DDC. A portion of these tests can only
be performed by customer service.
en
4.4 Troubleshooting
i In the case of transmission problems during control
unit diagnosis, please see the notes in section 3.6.
4.4.1 Diagnostic device not found
No diagnostic device (KTS 560 / 590) was found during
startup of the on board diagnosis software or commu-
nication with the control unit. The failure indication
Establish a connection with the communi-
cation module and connect with external
voltage supply or There is a fault in the
wireless connection with the KTS module is
displayed.
Possible causes What to do
No external voltage
supply.
Check whether the KTS module is supplied
with external voltage (power supply unit or
OBD connection cable).
The ON/OFF LED must light up green.
KTS module not
active or incorrectly
configured.
1. End the on board diagnosis.
2. Start DDC ("Start >> All Programs >>
Bosch ESI[tronic] 2.0 >> Diagnostic De-
vice Control").
3. In DDC check whether the KTS module
has been correctly configured and ac-
tivated.
4. Finally, test the KTS module.
No Bluetooth USB
adapter.
Bluetooth Manager symbol red
1. Plug in Bluetooth USB adapter.
2. Re-start control unit diagnosis.
4.4.2 No communication between PC/laptop and
KTS 560 / 590
Possible causes What to do
The Bluetooth USB
adapter included in
the scope of deliv-
ery is connected to
USB2.0 port.
Plug Bluetooth USB adapter into a USB
3.0 port.
4.4.3 No communication with control unit
During the control unit diagnosis, the following failure
indication appears: No communication with the
control unit. Adapter cable connected?
Possible causes What to do
Wrong cable
has been connect-
ed.
Check whether the correct cable has been
used.
i If problems of a different nature occur, please con-
tact the ESI[tronic] Service Hotline directly.
5.3 Spare and wearing parts
i The list only contains the replacement and wearing
parts included in the scope of delivery.
Designation Order number
Diagnostic device KTS 560 1 687 023 667
Diagnostic device KTS 590 1 687 023 668
OBD connection cable 1.5 m
<)
1 684 465 755
Power supply unit 1 687 023 736
Measuring cable red/black (KTS 590)
<)
1 684 463 945
Measuring cable blue/yellow (KTS 590)
<)
1 684 463 950
Measuring clamp black
<)
1 681 354 035
Test prods
<)
1 683 050 050
Test prods
<)
1 684 480 125
USB connection cable 3m
<)
1 684 465 562
Parts set for mount 1 687 016 137
Case 1 685 438 648
Bluetooth USB adapter 1 687 023 777
Protective cap
<)
1 680 591 037
<)
Wearing part
To Next Page
Loading...
Need help?
General
