Brother BAS-605 Series User Manual

[I] Adjusting the thread take-up (Required to assure thread remainderforsewing start.)
1. Make sure the thread take-up 0 does not hit the
arm and that it does not disrupt the thread's
passage.
(Adjustment)
Turn the
cylinder rod to adjust the position of the
thread take-up
0.
rmJ Adjusting the center knife assembly
(1) Adjusting the center knife
X
X
0
8mm
When the center knife guide 0 bottom is aligned with the tip of the center knife@, the clearance between
the center knife
@ tip and the needle plate 8 top should be 8 mm (the same height as the center knife
guideO).
(Adjustment)
loosen the
two stud screws e, and raise or lower the center knife @ so that the clearance between the
center knife@ and the needle plate 8 top is 8 mm. Tighten the stud screws e.
* Make sure that the center knife @ does not make contact with the fixed knife 0.
-47-
MODEL No. BAS-605, 610 SERIES
From the library of: Superior Sewing Machine & Supply LLC

Brother BAS-605 Series Specifications

General

Brand	Brother
Model	BAS-605 Series
Category	Sewing Machine
Language	English