Ill Adjusting
the
corner knives
(1) Adjusting
the
corner knife standard position
<Dimensional
drawing>
Sewing start
b
b
Sewing end
a
a
When
two
pieces
of
serge are sewn
after
corner knife position correction value
is
set
to
5-S
and center knife
correction value
is
set
to
0-0,
the
above dimensions should
be
1 mm.
* Change
the
corner knife position correction value according
to
material thickness.
When
the
ceramic corner knife
is
used,
the
dimensions may change according
to
the
knife position.
(2)
Adjusting
the
corner knife front-rear position (standard)
1.
Adjusting
the
corner knife position
at
the
end
of
sewing
2mm
1)
Set
the
MODE
switch
to
KNIFE
CHANGE
&
CYCLE
PGM.,
raise
the
corner knives
0,
and release
the
air.
2)
The corner knives 0 cutting position should be 1
mm in from
the
sewing end position
as
shown
in
Value
a.
Loosen
the
bolt
@ on
the
sewing end
side, and move
the
knife
base
assembly
@)
back
and
forth
to
adjust
it,
then retighten
the
bolt
0 .
3)
Loosen
the
bolt
0 on
the
sewing start side, and
adjust
the
knife
base
assembly
@)
back and
forth
so
that
the
clearance between the back
sides
of
the
two
corner knives 0
is
2 mm, then retighten
thebolt0.
-58-
*When
the
knife
base assembly is replaced
because
of
gauge replacement, replace one
knife
base
assembly (either on
the
sewing start
or
sewing end side), and adjust
the
clearance
to
2 mm. There should
be
no significant change in
the cutting position.
MODEL
No.
BAS-605,
610
SERIES
To Next Page
Loading...
Need help?
General
