5-13
Confidential
1.3.5 Worker Switch Setting and Printout (Maintenance modes 10 and 11)
[ 1 ] Worker switch setting (Maintenance mode 10)
< Function >
The worker switch functions customize the machine to meet various needs. They can
be activated with the procedures using the control panel keys.
The worker switches have been configured at the factory in conformity to the
communications standards and codes of each country. Do not disturb them unless
necessary.
* For details about the worker switches, refer to the document separately issued.
< Operating Procedure >
(1) Press the 1 and 0 keys in this order in the initial stage of the maintenance mode.
The machine displays the "WSW00" on the LCD.
(2) Enter a worker switch number to be modified.
The following appears on the LCD:
Selector 1 Selector 8
　↓ ↓
WSWXX = 0
0 0 0 0 0 0 0
(3) Press the
or key to move the cursor to the selector position to be modified.
Press the 0 or 1 key to change the setting.
(4) Press the
SET
key. This operation saves the newly entered selector values onto the
EEPROM and readies the machine for accepting a worker switch number ("WSW00").
(5) When all the switches are entered, press the X key to return the machine to the
initial stage of the maintenance mode.
Notes: - To cancel the setting and return to the initial stage of the maintenance mode,
press the X key.
- If there is a pause of more than one minute after a single-digit number is
entered for double-digit worker switch numbers, the machine automatically
returns to the initial stage of the maintenance mode.
To Next Page
Loading...
General
Weight and Dimensions
