Conguring Settings for Device Management Software
0W20-03W
You can facilitate the collection and management of various information about networked devices by implementing
device management software, such as imageWARE Enterprise Management Console
*
, into the network. Information
such as device settings and error logs is retrieved and distributed via the server computer. If the machine is connected
to such a network, imageWARE Enterprise Management Console searches the network for the machine by using
protocols such as Service Location Protocol (SLP) to gather information from the machine, including the power status.
SLP settings can be specied via the Remote UI.This section also describes how to congure communication settings
for the imageWARE Enterprise Management Console plug-ins.
*
For more information about imageWARE Enterprise Management Console, contact your local authorized Canon dealer.
Conguring SLP Communication with Device Management Software(P. 196)
Conguring Settings for Device Settings Management(P. 199)
To use imageWARE Enterprise Management Console plug-ins
● You need to enable dedicated port settings and SNMP settings. For SNMP settings, set [MIB Access
Permission] to [Read/Write] for both SNMPv3 and SNMPv1. plug-in. Dedicated Port Settings (P. 298)
Monitoring and Controlling the Machine with SNMP(P. 191)
Conguring
SLP Communication with Device Management Software
1
Start the Remote UI and log on in System Manager Mode. Starting Remote
UI(P. 270)
2
Click [Settings/Registration].
3
Click [Network Settings] [TCP/IP Settings].
Network
196