Print settings
• Prevent paper abrasion•
Use this setting only if the print surface becomes smudged.
Important
• Be sure to set this back to OFF after printing since it may result in lower printing speed or lower•
print quality.
• Amount of extension•
Selects the amount of image that extends off the paper when printing in borderless (full).
When performing Borderless Printing, slight cropping may occur at the edges since the printed image is
enlarged to fill the whole page. You can change the width to be cropped from the borders of the original
image as needed.
Important
• Settings will become ineffective in the following situations:•
Printing from a PictBridge (Wi-Fi) supporting device.
Printing from a standard form.
Note
• When performing settings from application software or the printer driver, these settings will be•
prioritized.
• If printouts contain margins even though you are printing in Borderless, specifying Extended•
amount: Large for this setting may help solve the problem.
• Auto photo fix settings•
When ON is selected, you can select whether to print photos using the Exif information recorded in
the image files when Default* or On is selected in printing with a PictBridge (Wireless LAN) compliant
device.
* When Default is selected for the print setting on the PictBridge (Wi-Fi) compliant device, select Auto
photo fix for Photo fix in PictBridge settings.
• Adjust horizontal print position•
Adjusts the print position when the left/right margins are not aligned.
You can adjust the left/right margins in increments of 0.004 in. (0.1 mm) between -0.12 in. (-3 mm) and
+0.12 in. (+3 mm) centered on the horizontal center of the paper.
Important
• For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.06 in. (-1.5•
mm) and +0.06 in. (+1.5 mm) even if you specify the value over 0.06 in. (1.5 mm).
204
To Next Page
Loading...
Need help?
General