23
Basic Functions
Turning the Power On/Off
Turning the Power On
1 Press the ON/OFF button until the
upper indicator next to the
viewfinder lights green.
Shooting Mode
z Current shooting settings will appear in the
LCD monitor.
z Current shooting settings will disappear
in about 6 seconds when the LCD
monitor is set to Standard (No
information) or No Display(p. 26).
z
If you turn the mode switch to , the lens
will retract after approximately 1 minute.
Playback Mode
z The LCD monitor displays an image.
Turning the Power Off
z Press the ON/OFF button again to turn the
power off.
z If the "Card locked!" message appears
right after the power is turned on, the SD
card cannot record (p. 15).
z
You will hear a start-up sound and see the
start-up image when the power comes on.
(To change the start-up sound and image,
see below and p. 71 and 106.)
z The start-up image does not appear
when the LCD monitor is off in Shooting
mode or the A/V OUT terminal is
connected to a TV.
Turning on the camera without the
start-up sound and image
Press and hold the SET button, then
turn on the power.
To Next Page
Loading...
Need help?
General
