79
Shooting – Advanced Functions
- The zoom is positioned to the
telephoto end setting.
Set the digital zoom to [Off].
- A mode other than , is
selected.
In
, mode, white balance data
cannot be read.
- The flash is set to (Flash On) or
(Flash Off).
Use the same flash setting as the one
that will be used for shooting when
you set the white balance. If the white
balance setting conditions and
shooting conditions are not the same,
the correct white balance may not be
obtained. When the flash is set to
,
(Auto with redeye reduction) or
(Auto), the flash may fire while the
white balance data is recorded to the
custom white balance. If this happens,
make sure the flash also fires when
you shoot the image.
- The ISO speed is set to the same
setting to shoot the image.
z The custom white balance setting is not
canceled even if settings are reset to
default settings (p. 72).
Changing the ISO Speed
Raise the ISO speed when you wish to
reduce camera shake, when turning the flash
off for use in dark conditions, or when a fast
shutter speed is required.
1 Select *(ISO Speed) from the
FUNC. menu.
z See Selecting Menus and Settings (p. 62).
* The current setting is displayed.
2 Press or to
select the ISO
speed.
z A shot can be taken
immediately by
pressing the shutter
button. The menu will
reappear after the
shot, allowing you to
adjust the setting.
3 Press the FUNC. button.
Shooting Mode
To Next Page
Loading...
Need help?
General
