176
Read operation and Read operation 2 Tabs
These tabs are to set up the following parameters related to scanning bar code symbologies.
Choose a mode you wish to set up in each pull-down menu.
Mode selection on Read operation Tab
• Continuous read or Single read
• Swing Angle Wide, Swing Angle Middle, or Swing Angle Narrow (Note 1)
• Enable Laser Focus or Disable Laser Focus (Note 2)
• Output OBR buffer or Output Clipboard or Output Keyboard
• Disable termination code or Termination code CR, LF, CR, LF, TAB
• Selection of the decoding level, "Normal" or "High" or "Steady".
• Normal read or Gradation read (Note 3)
• With or without filter, or with hard filter/with soft (Note 4)
Mode selection on Read operation 2 Tab
• Selection of the gain, Gain Mode0 to Mode3 or Auto.
• Learning Decode ON or Learning Decode OFF
Notes:
1. The function is named “Scan Width Control” function.
2. The function is named “Scan Verification Beam” function.
3. “Gradation read” is named “Multi-step read”.
4. Selection on “Without filter” or “With soft filter” is valid. Other selections in the pull-down
menu do not effect because the hardware filter is not integrated in the terminal.
Figure 3-53 Figure 3-54
To Next Page
Loading...
Need help?
General
