138
Viewing Snapshots and Movies
NOTE
• Use a HDMI cable that with a plug that is compatible with the camera’s HDMI micro
connector on one end, and a plug that is compatible with your TV’s HDMI
connector on the other end.
• Proper image and/or audio output and other operations may not be possible with
some devices.
• Connecting the camera to the HDMI connector of another device can damage both
the camera and the other device. Never connect two HDMI output connectors to
each other.
• Disconnect the HDMI cable when you are not using HDMI output. The camera’s
monitor screen may not operate normally while the HDMI cable is connected.
• Audio is stereo.
. Selecting the HDMI Terminal Output Method (HDMI Output)
Procedure
[MENU] * “¥ SETTING” Tab * HDMI Output
Use this setting to select the digital signal format when connecting to a TV with an
HDMI cable.
* 1080i corresponds to 1080 60i, but not 1080 50i. Because of this, the required
output method may be 576p when outputting to a digital TV in a PAL reception area
that does not support 1080i 60i. If you are in a PAL reception area and nothing is
displayed automatically, change the setting to 576p.
• If an image does not appear when “Auto” is selected as the output method, try
changing this setting to something else.
IMPORTANT!
• The “HDMI Output” setting cannot be changed as long as there is an HDMI cable
connection between the camera and a TV. Disconnect the HDMI cable from the
camera to change the “HDMI Output” setting.
Auto
This setting will cause the format to change automatically in accordance
with the connected TV. Normally, you should use this mode.
1080i 1080i format output*
480p 480p format output
576p 576p format output
To Next Page
Loading...
Need help?
General
