87
Recording Movies
• To adjust brightness when shooting with the Time Lapse “Night Scene”, use
“
S
” (Shutter Speed) on the Control Panel (page 44) to adjust the shutter speed.
. Using the Scene Information Screen
To find out more about a scene, select it with the boundary
on the scene menu and then rotate the zoom controller in
either direction.
• To return to the scene menu, rotate the zoom controller
again.
• To scroll between scenes, use [4] and [6].
• To configure the camera with the settings for the currently
selected scene, press [SET].
You can shoot snapshots while movie recording is in progress. When the camera is in
the Single Shot mode, you can shoot snapshots one-by-one. In the CS mode, holding
down the shutter button will record up to seven consecutive images at a speed of
approximately 10 images per second (fps). You can shoot a maximum total of
28 images during a single movie recording operation.
Shooting a Snapshot while Shooting a Movie
(Snapshot In Movie)
1. While a movie is being recorded, press the
shutter button.
• In the CS mode, images continue to be shot as long
as you keep the shutter button depressed.
• While movie recording is in progress, you can toggle
between the Single Shot Mode and the CS mode by
pressing [4], [6], or [SET]. Note that this method
for mode switching is possible only during movie
recording. The CS mode is indicated when is
white (on the monitor screen), and the Single Shot
mode is selected when t is white.
Number of recordable
snapshots
Snapshot
recording mode
To Next Page
Loading...
Need help?
General
