I
Compass Operation
Press the
COMP
switch once briefly to turn the compass
on or off.
When the ignition and the compass feature are
on,
the
compass will show two character boxes for
approximately two seconds. After two seconds, the
mirror will display the compass heading.
When cleaning the mirror, use a paper towel or similar
material dampened with glass cleaner.
Do
not spray
glass cleaner directly on the mirror as that may cause the
liquid cleaner to enter the mirror housing.
2:
I
Compass Calibration
Mirror Operation
The right side of the switch located at the bottom of the
mirror turns the electrochromic mirror on and off. The
AUTO
LED
will come on when the electrochromic
mirror is turned on.
To
turn the mirror on, press
and hold the MIRROR button for three seconds. The
mirror will darken and remain dark until the button is
released.
To
turn
the mirror
off,
press and release the
MIRROR button.
If, after two seconds, the display does not show a
compass heading
(“N”
for North, for example), there
may be a strong magnetic field interfering with the
compass. Such interference may be caused by a
magnetic antenna mount, magnetic note pad holder or a
similar magnetic item. If the letter
“C”
should ever
appear in the compass window, the mirror may
need calibration.
2-45
To Next Page
Loading...
Need help?
General
