TUNE:
Turn the lower knob to tune in radio stations.
SEEK:
Press the right arrow to tune to the next higher
station and the left arrow to tune to the next lower
station and stay there.
SCAN:
Press both SEEK buttons to listen to a few
seconds of each radio station. SCAN will light up on the
display. Press the right arrow to tune in the next higher
station and press the left arrow to tune to the next lower
station. Press
VOLUME
or both SEEK buttons to
stop scanning.
PUSHBUTTONS:
The four numbered pushbuttons let
you return to your favorite stations. You can set up to
14 stations (seven AM and seven FM). Just:
1.
Turn the radio on.
2.
Press AM-FM to select the band.
3.
Tune in the desired station.
4. Press SET. (SET will appear on the display.)
5.
Press and hold one of the four pushbuttons within
five seconds. Whenever you press that numbered
button, the station you set will return.
6.
Repeat the steps for each pushbutton.
In addition to the four stations already set, up to three
more stations may be preset on each band by pressing
two adjoining buttons at the same time. Just:
1.
Tune in the desired station.
2.
Press SET. (SET will appear on the display.)
3.
Press two adjoining buttons at the same time, within
five seconds. Whenever you press the same two
buttons, the station you set will return.
4. Repeat the steps for each pair of pushbuttons.
Setting
the
Tone
BASS:
Slide this lever up or down to increase or
decrease bass.
TREB:
Slide this lever up or down to increase or
decrease treble. If a station is weak or noisy, you may
want to decrease the treble.
Adjusting the
Speakers
BAL:
Turn the control behind the upper knob to move
the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE:
Turn the control behind the lower knob to move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
3-11
To Next Page
Loading...
Need help?
General
