NOTICE:
Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage.
To
avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper
torque specification.
11.
Put the wheel trim back on. For vehicles with plastic
wheel nut caps, tighten the caps until
they
are finger
tight, then tighten them an additional one-half of a
turn
with the ratchet and wheel wrench.
Storing
a
Flat or Spare Tire and Tools
Storing a jack,
a
tire or other equipment in the
passenger compartment
of
the vehicle could
cause injury. In a sudden stop or collision, loose
equipment could strike someone. Store all these
in the proper place.
Store the flat tire where the spare tire is stored.
Put the tools into the storage box and close it tightly. Fit
the storage box on the bracket with the bolt through the
box. Put the jack onto the box. Be sure the jack is stored
as shown in the following illustrations. The jack handle
attachment point is circled in the following illustrations
to show the direction
the
jack should face when it is
stored properly. Secure the emergency gloves,
if
your
vehicle has them, to the jack using the provided strap.
Slide the retainer over the bolt onto the jack and put the
wing nut on it. Turn the nut to the right until it is tight
against the retainer.
Replace the jack storage cover, if your vehicle has
one, by simply reversing the removal procedure
described earlier.
5-34
To Next Page
Loading...
Need help?
General
