Then, store the head
restraints by sliding them
into the rear of the seat
cushion. Make sure the
posts
go
in all the way.
To
return the seat to the passenger position, fist remove
the head restraints by sliding them out of the seat cushion.
Lift the seatback up and push rearward all the way. Then,
lower the seat cushion until it latches in position.
After returning the seat to the passenger position, return
the head restraints to the top of the seatback. Pull
forward on the seatback and up on the seat cushion to
make sure that the seat
is
securely in place.
If
the latch plate portion
of
the center safety belt was put
in the center armrest when the seat was folded, take the
latch plate portion out and place it on the seat. That way,
the center position safety belt will be available for the
center rear seat passenger to use.
Folding the Second Seat
(Suburban)
If
your vehicle has a
60/40
rear seat, either side may
be folded down to give you more
cargo
space.
Before folding, place the latch portion
of
the center
safety belt in the center armrest. That way, the center
safety belt will be out of the way when the seat is folded
and also will be easily available for passengers to use
when the seat is returned to the passenger position. Also,
make sure that nothing is under
or
in front
of
the seat.
When the seat is folded,
it
will lay flat on the floor.
When folding the seat,
first remove the head
restraints. Push the release
buttons at the bottom of
Set the head restraints aside for now. You will store
them in their proper positions after you are done
folding the seat.
1-11
To Next Page
Loading...
Need help?
General
