Cisco 3750G - Catalyst Integrated Wireless LAN Controller User Manual

44-4
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 44 Configuring Online Diagnostics
Displaying Online Diagnostic Tests and Test Results
16:44:45: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the stack
16:45:00: %STACKMGR-5-SWITCH_READY: Switch 1 is READY
16:45:00: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 1 has changed to state UP
16:45:00: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 1 has changed to state UP
00:00:20: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the stack (Switch-1)
00:00:20: %STACKMGR-4-SWITCH_ADDED: Switch 2 has been ADDED to the stack (Switch-1)
00:00:25: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan (Switch-1)
00:00:29: %SYS-5-CONFIG_I: Configured from memory by console (Switch-1)
00:00:29: %STACKMGR-5-SWITCH_READY: Switch 2 is READY (Switch-1)
00:00:29: %STACKMGR-5-MASTER_READY: Master Switch 2 is READY (Switch-1)
00:00:30: %STACKMGR-5-SWITCH_READY: Switch 1 is READY (Switch-1)
00:00:30: %DIAG-6-TEST_RUNNING: Switch 1: Running TestPortAsicLoopback{ID=2} ...
(Switch-1)
00:00:30: %DIAG-6-TEST_OK: Switch 1: TestPortAsicLoopback{ID=2} has completed successfully
(Switch-1)
You see this message if the test will cause a stack partition:
Switch 6: Running test(s) 2 will cause the switch under test to reload after completion of
the test list.
Switch 6: Running test(s) 2 will partition stack
Switch 6: Running test(s) 2 may disrupt normal system operation
Do you want to continue? [no]:
Displaying Online Diagnostic Tests and Test Results
You can display the online diagnostic tests that are configured for specific switches and check the results
of the tests using the show commands.
To display the diagnostic tests that are configured for a switch and the test results, use these privileged
EXEC commands:
This example shows how to display the online diagnostics that are configured on a switch:
Switch# show diagnostic content switch 3
Switch 3:
Diagnostics test suite attributes:
B/* - Basic ondemand test / NA
P/V/* - Per port test / Per device test / NA
D/N/* - Disruptive test / Non-disruptive test / NA
S/* - Only applicable to standby unit / NA
X/* - Not a health monitoring test / NA
F/* - Fixed monitoring interval test / NA
Table 44-1 show diagnostic Commands
Command Purpose
show diagnostic content switch [num | all] Display the online diagnostics configured for a switch.
show diagnostic status Display whether a switch is running a test.
show diagnostic result switch [num | all] detail
show diagnostic result switch [num | all] test [test_id |
test_id_range | all] [detail]
Display the online diagnostics test results.
show diagnostic schedule switch [num | all] Display the online diagnostics test schedule.
show diagnostic post Display the results of POST. (The same as the show post
command.)

Cisco 3750G - Catalyst Integrated Wireless LAN Controller Specifications

General

Brand	Cisco
Model	3750G - Catalyst Integrated Wireless LAN Controller
Category	Wireless Router
Language	English