7-4
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 7 Administering the Switch
Managing the System Time and Date
These sections contain this configuration information:
• Default NTP Configuration, page 7-4
• Configuring NTP Authentication, page 7-4
• Configuring NTP Associations, page 7-5
• Configuring NTP Broadcast Service, page 7-6
• Configuring NTP Access Restrictions, page 7-8
• Configuring the Source IP Address for NTP Packets, page 7-10
• Displaying the NTP Configuration, page 7-11
Default NTP Configuration
Table 7-1 shows the default NTP configuration.
NTP is enabled on all interfaces by default. All interfaces receive NTP packets.
Configuring NTP Authentication
This procedure must be coordinated with the administrator of the NTP server; the information you
configure in this procedure must be matched by the servers used by the switch to synchronize its time to
the NTP server.
Beginning in privileged EXEC mode, follow these steps to authenticate the associations (communications
between devices running NTP that provide for accurate timekeeping) with other devices for security
purposes:
Table 7-1 Default NTP Configuration
Feature Default Setting
NTP authentication Disabled. No authentication key is specified.
NTP peer or server associations None configured.
NTP broadcast service Disabled; no interface sends or receives NTP broadcast packets.
NTP access restrictions No access control is specified.
NTP packet source IP address The source address is set by the outgoing interface.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ntp authenticate Enable the NTP authentication feature, which is disabled by
default.
To Next Page
Loading...
Need help?
General
