14
Product Overview
Power-Supply Side
Dual-Purpose Port LEDs
The dual-purpose port LEDs identify the connection as either a copper-based connector or an SFP module. The ports
can autonegotiate, or you can manually configure each dual-purpose port as either 10/100/1000 with copper connectors
or as an SFP-module port, but not as both types at the same time. See Table 8 on page 13 for LED descriptions.
SD Flash Memory Card LED
SD Flash Memory Card
The switch ships with the Secure Digital (SD) flash memory card installed. See Figure 1 on page 6 and Figure 2 on
page 6. The switch stores the Cisco IOS software images and the switch configuration on the card. You should not
remove the card unless you want to use it in a replacement switch. You then do not have to reconfigure the new switch.
See the Replacing the SD Flash Memory Card, page 41 for information.
Power-Supply Side
The power-supply side has the LED panel and two power-supply slots for the removable power supplies. See Figure 7
on page 14 and Figure 8 on page 15.
Figure 7 Switch with One Power-Supply Module
Table 10 SD Flash Memory Card LED
Color System Status
Off / blinking green SD flash memory card transfer in progress.
Blinking amber SD flash memory card is not present (slow blinking).
Unsupported SD flash memory card is detected (fast blinking).
Amber Error accessing the SD flash memory card.
Cisco IOS boot image cannot be found.
Green SD flash memory card is functioning.
1 LED panel 3 Power-supply slot 2
2 Power-supply slot 1
2
1
3
208365
Cisco
Sw itch Series
IE 3010
PW R-RGD-LOW -DC
To Next Page
Loading...
Need help?
General