84
Configuring the Switch with the CLI Setup Program
Accessing the CLI Through the Console Port
— 9600 baud
— 8 data bits
— 1 stop bit
— No parity
— None (flow control)
7. Connect power to the switch as described in Power Supply Installation, page 47
The PC or terminal displays the bootloader sequence.
8. Press Enter to display the setup prompt.
9. Follow the steps in the Completing the Setup Program, page 86.
Installing the Cisco Microsoft Windows USB Device Drivers
Installing the Cisco Microsoft Windows XP USB Driver
1. Obtain the file Cisco_usbconsole_driver.zip from Cisco.com, and unzip it.
Note: You can download the driver file from the Cisco.com software download site.
— If using 32-bit Windows XP, double-click the setup.exe file in the Windows_32 folder.
— If using 64-bit Windows XP, double-click the setup(x64).exe file in the Windows_64 folder.
The Cisco Virtual Com InstallShield Wizard begins.
The Ready to Install the Program window appears.
2. Click Install.
The InstallShield Wizard Completed window appears.
3. Click Finish.
4. Connect the USB cable to the PC and to the switch console port.
The USB console port LED turns green, and the Found New Hardware Wizard appears.
5. Follow the instructions to complete the driver installation.
Installing the Cisco Microsoft Windows 2000 USB Driver
1. Obtain the file Cisco_usbconsole_driver.zip from Cisco.com, and unzip it.
Note: You can download the driver file from the Cisco.com software download site.
2. Double-click the setup.exe file.
The Cisco Virtual Com InstallShield Wizard begins.
3. Click Next.
The Ready to Install the Program window appears.
To Next Page
Loading...
Need help?
General