86
Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
Using the Setup.exe Program
Note: Disconnect the switch console terminal before uninstalling the driver.
1. Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64-bit. Click Next.
2. The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
3. When the Program Maintenance window appears, select the Remove radio button. Click Next.
4. When the Remove the Program window appears, click Remove.
5. When the InstallShield Wizard Completed window appears, click Finish.
Uninstalling the Cisco Microsoft Windows Vista USB Driver
Note: Disconnect the switch console terminal before uninstalling the driver.
1. Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
2. The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
3. When the Program Maintenance window appears, select the Remove radio button. Click Next.
4. When the Remove the Program window appears, click Remove.
Note: If a User Account Control warning appears, click Allow - I trust this program to proceed.
5. When the InstallShield Wizard Completed window appears, click Finish.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch powers on. You
must assign an IP address and other configuration information necessary for the switch to communicate with the local
routers and the Internet.
IP Settings
You need this information:
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Completing the Setup Program
Follow these steps to complete the setup program and to create an initial configuration for the switch:
1. Enter Yes at the following prompts:
Would you like to enter the initial configuration dialog? [yes/no]: yes
To Next Page
Loading...
Need help?
General