17
Cisco Systems, Inc. www.cisco.com
Switch Installation
Read the topics and perform the procedures in this order:
Warnings, page 17
Installation Guidelines, page 18
Verifying Switch Operation, page 18
Installing the Switch, page 19
Installing and Removing SFP Modules, page 35
Inserting and Removing the SFP Module Patch Cable, page 40
Replacing the SD Flash Memory Card, page 41
Connecting Devices to the Ethernet Ports, page 44
Where to Go Next, page 46
Warnings
These warnings are translated into several languages in the Regulatory Compliance and Safety Information for the Cisco
IE 3010 Switch document that ships on the documentation CD.
These warning statements apply to all the switches:
Warning: Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious
burns or weld the metal object to the terminals. Statement 43
Warning: Read the installation instructions before you connect the system to its power source. Statement 1004
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning: This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning: This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning: Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning: Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
To Next Page
Loading...
Need help?
General