30
Switch Installation
Installing the Switch
Wall-Mounting
To wall-mount the switch, follow the steps in these sections:
Attaching Brackets, page 31
Attaching Brackets for IP-30 Compliance (Optional), page 31
Wall-Mounting the Switch, page 32
Warning: Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct
hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the
system. Statement 378
Warning: For mounting railway-application equipment and for EN50155 standard compliance, the switch must be
installed only in a rack mid-mounting position. If you install the switch in a front rack-mounting (cable side or power
supply side) position or in a wall-mounting position, a mechanical failure can occur that results in the switch
becoming detached from the rack. Statement 403
If the switch is wall-mounted in an enclosure, follow these minimum clearances:
Sides of switch (facing up and facing down): 3.75 in. (9.52 cm)
Port side 3.0 in. (7.62 cm)
Power supply side: 5.25 in. (13.33 cm)
Cover side (side not facing wall): 1.75 in. (4.44 cm)
Base side (facing wall): 0 in. (0 cm)
To Next Page
Loading...
Need help?
General