Section 11: Utilities
173
When Halt After Recording is turned ON the spectrum or waveform
remains on the display until you choose to take the next recording.
If Halt After Recording is OFF recordings will only be displayed for
two seconds before the instrument returns automatically to the
Select Parameter Set Menu (or the Auto Route Menu if you are
recording a route).
• To turn on Halt After Recording, from the Main Menu press
Options.
• Press
to change this option from OFF to ON. To turn off
Halt After Recording press
repeatedly to cycle through
the options until OFF is displayed.
• Halt After Recording can be enabled temporarily for just the
newest reading by pressing
at any time while the
measurement is being taken.
With the display halted you can use the cursor and zooming features
to review the chart before deciding to accept (record) it or reject it
and re-take the recording. This option also applies during Auto
Route.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
