Section 1: Introduction
8
Operating Overview
The instrument can be used to perform the following tasks:
• Taking live measurements for onsite analysis of vibration
spectra and waveforms
• Recording of vibration data for transferral to a PC
• Single and dual plane balancing
Onsite Analysis (Measure Mode)
Vibration spectra and waveforms are measured and analyzed onsite.
This is suitable for one-off investigations and involves these steps:
• Measurement parameters are set on the instrument.
• The spectrum or waveform is measured and analyzed
onsite.
• The data is recorded to memory (optional).
• The data is transferred to a PC for further analysis (optional).
See Onsite Analysis (page 28) for more information.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
