DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
Figure 133. The page for adding a static route.
You can specify the following parameters:
Parameter Description
Destination network
A destination network to which this route is assigned.
Destination netmask The destination network mask.
Gateway
An IP address through which the destination network can be accessed.
The filed is displayed when the <Auto> value is selected from the Via
Interface drop-down list.
Metric
A metric for the route. The lower the value, the higher is the route
priority. Optional.
Via Interface
Select an interface through which the destination network can be
accessed from the drop-down list. If you have selected the <Auto>
value of this drop-down list, the access point itself sets the interface on
the basis of data on connected networks.
Click the Save button.
To edit an existing route, click the relevant route link. On the opened page, change the needed
parameters and click the Save button.
To remove an existing route, click the relevant route link. On the opened page, click the Delete
button.
Page 152 of 175
To Next Page
Loading...
Need help?
General
Weight and Dimensions
