D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Access Point Mode)
Advanced
This menu is designed for switching the operating modes of the device.
Device mode
On the Advanced / Device mode page, you can change the operating mode of the device.
Figure 52. The page for changing the operating mode of the device.
To switch the device to the other mode, select the Router value from the Work mode drop-down
list and click the Change button. Then select the Save&Reboot value from the top-page menu
displayed when the mouse pointer is over the System caption and wait until the device is rebooted.
!
When the device is switched to the router mode, you cannot connect to it via a wired
connection.
Page 63 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm