D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
Advanced
In this menu you can configure advanced settings of the access point switched to the router mode:
• enable the UPnP function
• configure a DDNS service
• add name servers
• define static routes
• switch the device to the other mode
• create rules for remote access to the web-based interface
• allow the access point to use IGMP.
UPnP
On the Advanced / UPnP page, you can enable the UPnP function.
UPnP is a set of networking protocols designed for automatic configuration of network devices. The
UPnP function performs automatic configuration of the device's parameters for network
applications requiring an incoming connection to the access point.
Figure 128. The Advanced / UPnP page.
If you want to manually specify all parameters needed for network applications, deselect the
Enabled checkbox and click the Change button.
If you want to enable the UPnP function in the access point, select the Enabled checkbox, select an
interface for which the device's parameters will be automatically configured from the Interface
drop-down list, and click the Change button.
Page 147 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm