D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Access Point Mode)
System Log
On the System / System log page, you can set the system log options and configure sending the
system log to a remote host.
Figure 57. The System / System log page. The Configuration tab.
To enable logging of the system events, select the Logging checkbox on the Configuration tab.
Then specify the needed parameters.
Control Description
Logging type
Select a type of logging from the drop-down list.
• Local: the system log is stored in the device's memory (and
displayed on the Log tab). When this value is selected, the
Server address type, Server, and Port fields are not
displayed.
• Remote: the system log is sent to the remote host specified in
the Server field.
• Local and remote: the system log is stored in the device's
memory (and displayed on the Log tab) and sent to the
remote host specified in the Server field.
Logging level Select a type of messages and alerts/notifications to be logged.
Server address type
From the drop-down list, select the IP value to specify an IP address
of a host from the local or global network, or the URL value to
specify a URL address of a remote server.
Server
The IP or URL address of the host from the local or global network,
to which the system log will be sent.
Port
A port of the host specified in the Server field. By default, the
value 514 is specified.
Page 67 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm