D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
System
In this menu you can do the following:
• change the password used to access the access point's settings
• save the current settings to the non-volatile memory
• create a backup of the access point's configuration
• restore the access point's configuration from a previously saved file
• restore the factory default settings
• view the system log
• update the firmware of the access point
• configure automatic synchronization of the system time
• allow or forbid access to the access point via TELNET.
Administrator Password
On the System / Administrator password page, you can change the password for the
administrator account used to access the web-based interface of the access point and to access the
device settings via TELNET.
!
For security reasons, it is strongly recommended to change the administrator password
upon initial configuration of the access point.
Figure 148. The page for modifying the administrator password.
Enter the new password in the Password and Confirmation fields and click the Save button.
Page 166 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm