D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
MAC Filter
On the Firewall / MAC filter page, you can configure MAC-address-based filtering for computers
of the device's LAN.
Figure 143. The Firewall / MAC filter page.
To specify a new address for the MAC filter, click the Add button.
Figure 144. The page for adding an address for the MAC filter.
On the opened page, enter the MAC address of the device from the access point's LAN in the MAC
address field. To choose a device connected to the access point's LAN at the moment, select the
relevant value from the drop-down list located to the right of the field (the field will be filled in
automatically). Then select the Deny value from the Action drop-down list and click the Change
button.
To remove an address from the list of MAC addresses for filtering, select the line with the relevant
MAC address. On the opened page, click the Delete button.
Page 163 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm