D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Access Point Mode)
MAC Filter
On the Wi-Fi / MAC Filter page, you can define a set of MAC addresses of devices which will be
allowed to access the WLAN, or define MAC addresses of devices which will not be allowed to
access the WLAN.
Figure 43. The MAC filter for the wireless network.
By default, MAC filtering is not active (the Disabled choice of the MAC filter restrict mode
radio button is selected).
To open your wireless network for the devices which MAC addresses are specified on the MAC
addresses tab and to close the wireless network for all other devices, select the Allow choice of
the MAC filter restrict mode radio button and click the Change button.
To close your wireless network for the devices which MAC addresses are specified on the MAC
addresses tab, select the Deny choice of the MAC filter restrict mode radio button and click
the Change button.
To add a MAC address to which the selected filtering mode will be applied, proceed to the MAC
addresses tab.
Page 48 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm