D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
Control
This menu is designed to create restrictions on access to certain web sites.
URL Filter
On the Control / URL filter page, you can specify restrictions on access to certain web sites.
Figure 145. The Control / URL filter page. The Configuration tab.
To enable the URL filter, select the Enable/Disable URL filter checkbox on the Configuration
tab, then select a needed mode from the URL filter type drop-down list:
• Block listed URLs: when this value is selected, the access point blocks access to all
addresses specified on the URL addresses tab;
• Block all URLs except listed: when this value is selected, the access point allows access
to addresses specified on the URL addresses tab and blocks access to all other web sites.
Click the Change button.
To specify URL addresses to which the selected filtering will be applied, go to the URL
addresses tab and click the Add button.
Page 164 of 175

D-Link DAP-1150 Specifications

General

Frequency band	2.4 GHz
Ethernet LAN data rates	100 Mbit/s
Maximum data transfer rate	54 Mbit/s
Connectivity LEDs	WLAN, LAN, WPS
Wireless technology	802.11g/b
Antenna gain level (max)	2 dBi
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, AES, EAP-SIM, PEAP, SSL/TLS, TKIP, TTLS, WPA-EAP, WPA-PSK, WPA2-EAP, WPA2-PSK
Operating temperature (T-T)	0 - 55 °C
Certification	FCC Class B, CE, C-Tick, Wi-Fi
Power requirements	5VDC 1.2A

Weight and Dimensions

Weight	220 g
Dimensions (WxDxH)	144 x 109 x 30 mm