DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Installation and Connection
Saving and Restoring Settings
!
Note that you should regularly save the changes of the device's settings to the non-
volatile memory.
The web-based interface displays the notification on unsaved changes at the top of the page.
Figure 22. The notification on unsaved changes.
You can save the device's settings via the top-page menu displayed when the mouse pointer is over
the System caption.
Figure 23. The top-page menu.
Click the Reboot line if you have already saved the device's settings.
Click the Save&Reboot line to save new settings and immediately reboot the access point.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the access point) to your PC. Also you can save the device's configuration to your PC via the
Backup button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware RESET button. The button is
located on the back panel of the access point next to the power connector.
To restore the factory default settings, do the following:
1. Power off the device.
2. Insert a small paperclip into the hole of the RESET button and push.
3. Power on the device keeping the button pushed.
4. After 5 seconds, release the button.
Wait for about 30 seconds. Now you can access the web-based interface of the access point using
the default IP address, username and password.
Page 29 of 175
To Next Page
Loading...
Need help?
General
Weight and Dimensions
