Name: D-Link DIR-815
Brand: D-Link
Rating: 5 (1 reviews)

To Next Page

To Previous Page

DIR-815 AC1200 Wave 2 MU-MIMO Wi-Fi

Router with 3G/LTE Support and USB Port

User Manual

Configuring via Web-based Interface

Creating PPPoE IPv6 or PPPoE Dual Stack WAN Connection

On the connection creation page, in the General Settings section, select the relevant value from

the Connection type drop-down list and specify the needed values.

Figure 79. The page for creating a new PPPoE IPv6 connection. The General Settings section.

Parameter Description

General Settings

Interface

A physical or virtual WAN interface to which the new connection

will be assigned.

Connection name A name for the connection for easier identification.

Enable connection

Move the switch to the right to enable the connection.

Move the switch to the left to disable the connection.

NAT

For the PPPoE Dual Stack type only.

If the switch is moved to the right, the network address translation

function is enabled. Do not disable the function unless your ISP

requires this.

Page 100 of 240

Other manuals for D-Link DIR-815

Questions and Answers:

Need help?

Do you have a question about the D-Link DIR-815 and is the answer not in the manual?

Wireless Signal Rates

IEEE 802.11n 20MHz Channel 1Nss	65/72.2 Mbps (max)
IEEE 802.11n 20MHz Channel 2Nss	130/144.44 Mbps (max)
IEEE 802.11n 40MHz Channel 1Nss	135/150 Mbps (max)
IEEE 802.11n 40MHz Channel 2Nss	270/300 Mbps (max)
IEEE 802.11a	54 Mbps - 48Mbps - 36Mbps - 24Mbps - 18Mbps - 12Mbps - 9Mbps - 6Mbps
IEEE 802.11g	54Mbps - 48Mbps - 36Mbps - 24Mbps - 18Mbps - 12Mbps - 11Mbps - 9Mbps - 6Mbps

Wireless Frequency Range