Danfoss VLT CDS 803 Programming Guide

1 Introduction
1.1 Purpose of the Manual
This programming guide provides information for
advanced programming of the frequency converter. It
provides a complete overview and description of all
parameters.
The programming guide is intended for use by
qualied
personnel.
To operate the frequency converter safely and profes-
sionally, read and follow the programming guide, and pay
particular attention to the safety instructions and general
warnings.
1.2 Document and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome.
Edition Remarks Software version
MG18P2xx Update to new
software version.
2.0
Table 1.1 Document and Software Version
1.3
Safety Symbols
The following symbols are used in this guide:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.
1.4 Safety Precautions
WARNING
HIGH VOLTAGE
Frequency converters contain high voltage when
connected to AC mains input, DC supply, or load sharing.
Failure to perform installation, start-up, and maintenance
by qualied personnel can result in death or serious
injury.
•
Installation, start-up, and maintenance must be
performed by qualied personnel only.
WARNING
UNINTENDED START
When the frequency converter is connected to AC mains,
DC power supply, or load sharing, the compressor may
start at any time. Unintended start during programming,
service, or repair work can result in death, serious injury,
or property damage. The Compressor can start with an
external switch, a serial bus command, an input
reference signal from the LCP, or after a cleared fault
condition.
To prevent unintended Compressor start:
•
Disconnect the frequency converter from the
mains.
•
Press [O/Reset] on the LCP before
programming parameters.
•
The frequency converter, compressor, and any
driven equipment must be fully wired and
assembled when the frequency converter is
connected to AC mains, DC supply, or load
sharing.
Introduction Programming Guide
MG18P202 Danfoss A/S © 06/2019 All rights reserved. 3
1 1

Danfoss VLT CDS 803 Specifications

General

Brand	Danfoss
Model	VLT CDS 803
Category	DC Drives
Language	English