Danfoss VLT FC 302 User Manual

5 User Interface
5.1 How to Operate
5.1.1 Modes of Operation
There are 2 ways to operate the unit:
•
Graphical Local Control Panel (GLCP)
•
RS-485 serial communication or USB, both for PC
connection
5.1.2 How to Operate Graphical LCP (GLCP)
The Low Harmonic Drive has 2 LCPs, one each on the
frequency converter section (right) and active filter section
(left). Both LCPs function in the same way. Each LCP
controls only the unit it is connected to and there is no
communication between the 2 LCPs. How to operate
graphical LCP (GLCP)
NOTICE
The active filter should be in auto mode. Press [Auto On]
on the filter LCP.
The following instructions are valid for the GLCP (LCP 102).
The GLCP is divided into four functional groups:
•
Graphical display with status lines.
•
Menu keys and indicator lights (LEDs) - selecting
mode, changing parameters, and switching
between display functions.
•
Navigation keys and indicator lights (LEDs).
•
Operation keys and indicator lights (LEDs).
Graphical display:
The LCD display is back-lit with a total of 6 alpha-numeric
lines. All data is displayed on the LCP, which can show up
to five operating variables while in [Status] mode.
Illustration 5.1 shows an example of the frequency
converter LCP. The filter LCP looks identical but displays
information related to the filter operation.
1. Display
1a
Status line: Status messages displaying
icons and graphics.
1b
Line 1–2: Operator data lines displaying
data and variables the user defines. By
pressing the [Status] key, up to one
extra line can be added.
1c
Status line: Status messages displaying
text.
2. Menu soft keys
3. Indicator lights/navigation panel
4. Operational keys
Auto
on
Reset
Hand
on
O
Status
Quick
Menu
Main
Menu
Alarm
Log
Back
Cancel
Info
OK
Status
1(0)
1234rpm 10,4A 43,5Hz
Run OK
43,5Hz
On
Alarm
Warn.
130BA018.13
1
2
3
4
b
a
c
Illustration 5.1 LCP
The display is divided into 3 sections:
Top section (a)
Shows the status when in status mode or up to 2 variables
when not in status mode and in the case of alarm/
warning.
The number of the active set-up (selected as the active
set-up in 0-10 Active Set-up) is shown. When programming
in another set-up than the active set-up, the number of
the set-up being programmed appears to the right in
brackets.
User Interface
Operating Instructions
42 Danfoss A/S © Rev. 2014-07-29 All rights reserved. MG37A202
55

Danfoss VLT FC 302 Specifications

General

Brand	Danfoss
Model	VLT FC 302
Category	Controller
Language	English