Par. No. # Parameter description Default value 4-set-up FC 302
only
Change
during
operation
Conver-
sion
index
Type
1-6* Load Depen. Setting
1-60 Low speed load compensation 100 % All set-ups TRUE 0 Int16
1-61 High speed load compensation 100 % All set-ups TRUE 0 Int16
1-62 Slip compensation App.Dependent All set-ups TRUE 0 Int16
1-63 Slip compensation time constant App.Dependent All set-ups TRUE -2 Uint16
1-64 Resonance dampening 100 % All set-ups TRUE 0 Uint16
1-65 Resonance dampening time constant 5 ms All set-ups TRUE -3 Uint8
1-66 Min. current at low speed 100 % All set-ups x TRUE 0 Uint8
1-67 Load type [0] Passive load All set-ups x TRUE - Uint8
1-68 Minimum inertia App.Dependent All set-ups x FALSE -4 Uint32
1-69 Maximum inertia App.Dependent All set-ups x FALSE -4 Uint32
1-7* Start Adjustments
1-71 Start delay 0.0 s All set-ups TRUE -1 Uint8
1-72 Start function [2] Coast/delay time All set-ups TRUE - Uint8
1-73 Flying start null All set-ups FALSE - Uint8
1-74 Start speed [RPM] App.Dependent All set-ups TRUE 67 Uint16
1-75 Start speed [Hz] App.Dependent All set-ups TRUE -1 Uint16
1-76 Start current 0.00 A All set-ups TRUE -2 Uint32
1-8* Stop Adjustments
1-80 Function at stop [0] Coast All set-ups TRUE - Uint8
1-81 Min speed for function at stop [RPM] App.Dependent All set-ups TRUE 67 Uint16
1-82 Min speed for function at stop [Hz] App.Dependent All set-ups TRUE -1 Uint16
1-83 Precise stop function [0] Precise ramp stop All set-ups FALSE - Uint8
1-84 Precise stop counter value 100000 N/A All set-ups TRUE 0 Uint32
1-85 Precise stop speed compensation delay 10 ms All set-ups TRUE -3 Uint8
1-9* Motor Temperature
1-90 Motor thermal protection [0] No protection All set-ups TRUE - Uint8
1-91 Motor external fan [0] No All set-ups TRUE - Uint16
1-93 Thermistor resource [0] None All set-ups TRUE - Uint8
1-94 ATEX ETR cur.lim. speed reduction 0.0% 2 set-ups x TRUE -1 Uint16
1-95 KTY sensor type [0] KTY Sensor 1 All set-ups x TRUE - Uint8
1-96 KTY thermistor resource [0] None All set-ups x TRUE - Uint8
1-97 KTY threshold level 80 °C 1 set-up x TRUE 100 Int16
1-98 ATEX ETR interpol. points freq. App.Dependent 1 set-up x TRUE -1 Int16
1-99 ATEX ETR interpol points current App.Dependent 2 set-ups x TRUE 0 Int16
Programming Operating Instructions
76 Danfoss A/S © Rev. 2014-07-29 All rights reserved. MG37A202
66
To Next Page
Loading...
Need help?
General
