6.3.12 10-** CAN Fieldbus
Par. No. # Parameter description Default value 4-set-up FC 302
only
Change
during
operation
Conver-
sion index
Type
10-0* Common Settings
10-00 CAN protocol null 2 set-ups FALSE - Uint8
10-01 Baud rate select null 2 set-ups TRUE - Uint8
10-02 MAC ID App.Dependent 2 set-ups TRUE 0 Uint8
10-05 Readout transmit error counter 0 N/A All set-ups TRUE 0 Uint8
10-06 Readout receive error counter 0 N/A All set-ups TRUE 0 Uint8
10-07 Readout bus off counter 0 N/A All set-ups TRUE 0 Uint8
10-1* DeviceNet
10-10 Process data type selection null All set-ups TRUE - Uint8
10-11 Process data config write App.Dependent All set-ups TRUE - Uint16
10-12 Process data config read App.Dependent All set-ups TRUE - Uint16
10-13 Warning parameter 0 N/A All set-ups TRUE 0 Uint16
10-14 Net reference [0] Off 2 set-ups TRUE - Uint8
10-15 Net control [0] Off 2 set-ups TRUE - Uint8
10-2* COS Filters
10-20 COS filter 1 0 N/A All set-ups FALSE 0 Uint16
10-21 COS filter 2 0 N/A All set-ups FALSE 0 Uint16
10-22 COS filter 3 0 N/A All set-ups FALSE 0 Uint16
10-23 COS filter 4 0 N/A All set-ups FALSE 0 Uint16
10-3* Parameter Access
10-30 Array index 0 N/A 2 set-ups TRUE 0 Uint8
10-31 Store data values [0] Off All set-ups TRUE - Uint8
10-32 Devicenet revision App.Dependent All set-ups TRUE 0 Uint16
10-33 Store always [0] Off 1 set-up TRUE - Uint8
10-34 DeviceNet product code App.Dependent 1 set-up TRUE 0 Uint16
10-39 Devicenet F parameters 0 N/A All set-ups TRUE 0 Uint32
10-5* CANopen
10-50 Process data config write App.Dependent 2 set-ups TRUE - Uint16
10-51 Process data config read App.Dependent 2 set-ups TRUE - Uint16
Programming Operating Instructions
88 Danfoss A/S © Rev. 2014-07-29 All rights reserved. MG37A202
66
To Next Page
Loading...
Need help?
General
