Dell E24S User Manual

Figure 40. Removing and installing a PCIe module
a. PCIe module
b. release latch
Next steps
Install the PCIe module.
Related tasks
Installing a PCIe module on page 46
Installing a PCIe module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
CAUTION: The PCIe module is a warm-swappable component. The PCIe slot in a PCIe module is assigned to a
compute sled. Removing or adding a PCIe module while the compute sled to which it is assigned is on can result
in an error condition.
1. Ensure that you read the Safety instructions on page 33.
2. Remove the PCIe module.
NOTE:
You must remove a PCIe module to replace a faulty module, install or replace an expansion card in the PCIe
module, or service other components inside the system.
Steps
1. Remove the PCIe module connector cover.
2. Install an expansion card or filler bracket.
3. Slide the PCIe module into the enclosure until it engages with the connector on the PCIe switch board and the release latch
snaps into place.
Next steps
Turn on the compute sled to which the PCIe slot in the PCIe module is assigned.
Related information
Removing a PCIe module on page 45
46
Installing and removing PowerEdge FX2/FX2s enclosure components

Dell E24S Specifications

General

Brand	Dell
Model	E24S
Category	Enclosure
Language	English