ENGLISH
."
0;-
<
tT
III
"
,..
I
Remote Control Unit Operations
Main Remote Control Unit
IFront]
[MODE
_-----""--"'<:'1r~-
[MODE
SELECTOR
1]
~~~
SELECTOR
2]
[Rear]
Depending
on
the model
and
year of manufacture of your equipment,
some buttons may not operate.
43
IOperati
ll
9 D:ENON Audio'Components .
1Set
[MODE
SELECTOR
1] to "AUDIO".
2
Set
[MODE
SELECTOR
2] to the position for the
component to be operated (CD, iPodINETWORK or
TAPElCD-RlMD).
3Operate the audio component.
*
For
details, refer to the component's operating instructions.
*While this remote control
is
compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot
be
operated
with
this remote control.
1Set
[MODE
SELECTOR
1]
to "AUDIO" or "VIDEO".
*Set to the AUDIO side for the
CD,
iPod/NETWORK orTAPE/CD-R/
MD position, and to the VIDEO side for the
DVDNDP.
VCR,
SAT/
CABLE orTV position. .
2
Set
[MODE
SELECTOR
2] to the component to be
registered.
3
Press
[ZONEZ
OFF]
and
[MAIN
ON]
at the same time.
The
indicator starts flashing.
4
Referring to the included list
of
preset codes, press
[NUMBER]
to input the preset code (a 3-digit number)
for the manufacturer
of
the component whose signals
you want to store in the memory.
5
To
store the codes
of
another component in the
memory, repeat steps 1 to 4.
•
The
signals for the pressed buttons
are
emitted while setting the
preset memory.
To
avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending
on
the model
and
year
of
manufacture, this function
cannot
be
used for some models,
even
if they
are
of makes listed
in
the list of preset codes.
• Some manufacturers use more than one type
of
remote control code.
Refer to the included list of preset codes to change the number
and
verify correct operation.
•
The
preset memory
can
be
set for one component only among the
following: TAPE/CD-R/MD, DVDNDP and
SAT/CABLE.
IOperatitlgPreset,Components)
1Set
[MODE
SELECTOR
1]
to "AUDIO" or"VIDEO".
*Set to the AUDIO side for the
CD,
iPod/NETWORK orTAPE/CD-R/
MD position, and to the VIDEO side for the
DVDNDP.
VCR,
SAT/
CABLE orTV position.
2
Set
[MODE
SELECTOR
2] to the component you want
to operate.
3Operate the component.
*
For
details, refer to the component's operating instructions.
*Some models cannot
be
operated with this remote control unit.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
