ENGLISH
(RC-1075)
Point the remote control unit at the remote sensor when operating it.
i~[.U.
• Replace the batteries with
new
ones if the set does not operate even
when the remote control unit
is
operated close to the unit.
•
The
supplied batteries
are
only for verifying operation.
• When inserting the batteries,
be
sure to do
so
in
the proper direction,
following the
"EtJ"
and
"S"
marks
in
the battery compartment.
•
To
prevent damage or leakage
of
battery fluid:
• Do not use a new battery together with
an
old one.
• Do not use
two
different types of batteries.
•
Do
not attempt to charge dry batteries.
•
Do
not short-circuit, disassemble, heat or dispose of batteries
in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert
new
batteries.
• Remove the batteries from the remote control unit if it will not
be
in
use for long periods.
• When replacing the batteries,
have
the new batteries ready
and
insert them
as
quickly
as
possible.
Approx.
23
feet / 7 m
iN·U.
The
set
may
function improperly or the remote control unit may not
operate if the remote control sensor
is
exposed to direct sunlight,
strong artificial light from
an
inverter type fluorescent lamp or infrared
light.
(RC-l085l
(RC-1085l
R03/AAA
About
the
Remote Control
Unit
@
Load
the
two
batteries properly
as
indicated
by
the marks
in
the
battery compartment.
In
addition to the
AVR-1708,
the included main remote control unit
(RC-l075)
can
also be used to operate the equipment listed below.
CD
DENON system components
<Ii
Non-DENON system components
•
By
setting the preset memory (!3T'page 43 -
45)
<D
Lift the clasp
and
remove the rear lid.
~'/////-
I*Note
~
q
1°
c::::=J
10
*
I----
00
0
••
•
•••
fi:B
:0:
0
*
l,N//W////£i&D
W,II
Cautions on Handling
Note:
For
proper heat dispersal, do not install this unit in a confined ® Put the
rear
cover back on.
space,
such
as
a bookcase or similar enclosure.
Cautions on Installation
• Before turning the power switch
on
Check once again that
all
connections
are
correct and that there are
no
problems with the connection cables.
• Power
is
supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
• About condensation
If there
is.
a major difference
in
temperature between the inside
of
the unit and the surroundings, condensation (dew) may form
on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for
an
hour or
two
with the power
turned off and wait until there
is
little difference
in
temperature
before using the unit.
• Cautions
on
using mobile phones
Using a mobile phone near this unit may result
in
noise.
If
so,
move
the mobile phone away from this unit when it
is
in
use.
• Moving the unit
Turn
off the power and unplug the power cord from the power
outlet.
Next. disconnect the connection cables to other system units before
moving the unit.
• Note that the illustrations
in
these instructions may differ from the
actual unit for explanation purposes.
n
o
::l
::l
"
~
o'
::l
'"
I
3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
