78
Advanced Setup – Part 2 Advanced Setup – Part 2
Others Setup
Setting the Room EQ Setup
Select the setting of an Equalizer that has been set with Auto
Setup or Manual EQ.
1
Press the CURSOR
DD
or
HH
button to select
“Room EQ Setup” at “Auto Setup / Room EQ”
menu, then press the ENTER button.
• The “Room EQ Setup” screen appears.
2
Press the CURSOR
FF
or
GG
button to select “All”
or “Assign”.
All:
Sets the Equalizer for all surround modes.
Assign:
Sets the Equalizer individually for each surround mode.
Setting the Direct Mode Setup
Perform the ON/OFF setting of Room EQ when the surround
mode is “DIRECT” or “PURE DIRECT”.
1
Press the CURSOR
DD
or
HH
button to select
“Direct Mode Setup” at “Auto Setup / Room
EQ” menu, then press the ENTER button.
• The “Direct mode Setup” screen appears.
2
Press the CURSOR
FF
or
GG
button to select “ON”
or “OFF”.
3
-1
When “All” is selected:
qq
Press the ENTER button.
• The “Room EQ” screen appears.
3
-2
ww
Press the CURSOR
FF
or
GG
button to select the
equalizer setting.
OFF:
The Equalizer is not used.
Audyssey:
Adjusts the frequency response of all speakers to correct the
effects of room acoustics.
Front:
Adjusts the frequency response of the surround speakers to
match the characteristics of the front channel speakers.
Flat:
Adjusts the frequency response of all speakers to the flattest
response. This mode is suitable for multi-channel music
surround sound sources.
Manual:
Selects the setting value that was set in the Manual EQ
Setup.
For details of the “Manual EQ Setup” ( page 68, 69).
When “Assign” is selected:
After completing system setup, select the desired
equalizer setting pressing the ROOM EQ button.
• Equalizer settings for the individual surround modes can
be stored in the memory.
Whenever the ROOM EQ button is pressed, the display
switches as shown below.
4
Press the ENTER button to enter the setting.
• The “Auto Setup / Room EQ” menu reappears.
3
Press the ENTER button to enter the setting.
• The “Auto Setup / Room EQ” menu reappears.
• The Equalizer setting of “Audyssey”, “Front” and “Flat” can be
selected after performing the Auto Setup.
• When the speaker set as “None” with the Auto Setup is
changed to on manually, the equalizer of “Audyssey”, “Front”
and “Flat” cannot be used.
• The Equalizer setting can be selected directly by ROOM EQ
button.
• When headphones are connected, the Room EQ cannot be
used.
Setting the MIC Input Select
Sets whether the setup microphone is connected to the PIN
JACK (V.AUX L channel) connector or the MINI JACK (SETUP
MIC) connector.
1
Press the CURSOR
DD
or
HH
button to select “Mic
Input Select” at “Auto Setup / Room EQ” menu,
then press the ENTER button.
• The “Mic Input Select” screen appears.
2
Press the CURSOR
FF
or
GG
button to select “Mic”
or “V.Aux L”.
3
Press the ENTER button to enter the setting.
• The “Auto Setup / Room EQ” menu reappears.
ENGLISH
ENGLISH
To Next Page
Loading...
Need help?
General
