DigiTech JamMan Solo User Manual

17
You can undo your last overdub anytime
the current loop number selection
remains unchanged. If you change your
mind after undoing an overdub, you can
also redo the overdub.
Undo an Overdub
While the loop is playing, press and hold
the PEDAL SWITCH for two seconds
to undo your last overdub. The STATUS
LED will quickly flash yellow when the
undo takes place.
Redo an Overdub
While the loop is playing, press and hold
the PEDAL SWITCH to redo the last
undo; the STATUS LED will quickly flash
yellow again when the redo takes place.
Clear Overdubs and Unsaved Phrases
You can Clear overdubs from playback,
overdub, and stopped operation. From
playback/overdub, press the PEDAL
SWITCH 2 times quickly to stop playback
and continue holding it for 2 seconds until
the STATUS LED flashes red. From a
stopped state, press and hold the PEDAL
SWITCH for 2 seconds until the
STATUS LED flashes red. The flashing
red LED indicates unstored overdubs and
phrases have been cleared and only loop
content that is stored in memory will be
untouched. Selecting a different loop also
clears any unsaved phrases and overdubs.
Clearing can also be done using an FS3X
footswitch (see page 40).
NOTE: Clear and Overdub Undo/Redo
functions cannot be performed with the
loop after a Store/Copy procedure.
Undo/Redo Overdubs

DigiTech JamMan Solo Specifications

General

Brand	DigiTech
Model	JamMan Solo
Category	Music Pedal
Language	English