DigiTech JamMan Solo User Manual

32
The JamMan
®
Solo uses both internal
memory and optional external SD/SDHC
memory cards for the storage of loop
files. Loop phrases can be deleted one
at a time to make room for other loops.
You can delete loops from both internal
memory and from external memory.
To delete a loop from internal or external
memory, follow these steps:
Select the phrase you want to delete 1.
using the LOOP SELECT buttons.
If the CARD MEM LED is lit, you
have selected a loop on the optional
memory card.
Press and hold the 2. STORE button for
two seconds until the DISPLAY shows
EL and release. The STORE button
will begin flashing waiting for a delete
confirmation.
NOTE: If the DISPLAY shows
Ei
or
EC, you have held the STORE
button too long and need to abort this
procedure and start over. Press the
PEDAL SWITCH at this point to
abort the Delete procedure.
Press the 3. STORE button again. The
DISPLAY reads
E? (Erase Loop?).
The STORE button will continue to
flash. To abort this procedure at any
time, press the PEDAL SWITCH at
any time.
If you want to delete the contents 4.
from this memory location and return
it to its default state, press and hold
STORE button for two seconds. The
DISPLAY will briefly read
dE when
the delete procedure is complete and
then return to the memory number.
Deleting Individual Loop Phrases

DigiTech JamMan Solo Specifications

General

Brand	DigiTech
Model	JamMan Solo
Category	Music Pedal
Language	English