DigiTech JamMan Solo User Manual

20
2
3
4
1
1
Stop any playback or recording
activity by pressing the PEDAL
SWITCH two times quickly.
Press the STORE button.
The STORE button and
the DISPLAYwill begin to
flash (the DISPLAY shows
the current loop memory
location).
(Optional) Press the LOOP
SELECT buttons to select a
different empty memory
location to store the loop with
its changes (the LOOP or
SINGLE LEDs are off). You can
also store over existing loops if
you decide to. Press the PEDAL
SWITCH to abort
Press the STORE button again
to complete.
Storing Phrases
Anytime a change is made to a loop memory location (Rhythm Type, Tempo, Time
Signature, Record, Overdubs etc.) the Store button will immediately light indicating that
the changes will be lost unless a store procedure is performed before selecting a new
loop memory location or turning off the power.
NOTE: If dF appears in the display, this indicates the internal or external memory is full. Loops should be
archived using the JamManager
TM
librarian and then deleted from the JamMan
®
Solo to free up memory.
If when storing to an external SD card you see CP in the display, this indicates the SD copy
protection switch is in the “Locked” position.

DigiTech JamMan Solo Specifications

General

Brand	DigiTech
Model	JamMan Solo
Category	Music Pedal
Language	English