To Next Page

To Previous Page

Before you begin recording a phrase, you may want to set a tempo at which you want to

record the loop at. Setting the tempo in an empty loop memory location automatically

starts playing the rhythm guide track (Rhythm Level must be turned up to hear it). You can

use the rhythm guide track as a metronome for recording against to help keep a consistent

tempo of your performance. To set the tempo for recording, follow these steps:

Select an empty loop memory location

using the LOOP SELECT buttons

(LOOP and SINGLE LEDs are off).

Tap the TEMPO button at least two times, or if

Pedal Tempo is enabled, press the PEDAL

SWITCH at least two times. The TEMPO button

will begin flashing at the tempo that has been

tapped in. The first downbeat of the measure

flashes red and the other beats flash green. If

Pedal Tempo is enabled, you must press and hold

the PEDAL SWITCH for two seconds to fix the

tempo before you can record.

Turn up the RHYTHM LEVEL

knob (if it hasn’t been already)

to hear the rhythm guide track.

To begin recording, press the

PEDAL SWITCH, wait for the

one-measure count-in, and

begin playing.

Setting a Loop Tempo for Recording

To set up a memory location with a tempo but not record to it, follow steps 1 and 2 and

then store the new tempo using the Store procedure. When you return to the empty loop

location, the tempo will already be set as indicated by the Tempo button ﬂashing.

DigiTech JamMan Solo User Manual

Questions and Answers: