DigiTech JamMan Solo User Manual

28
Any phrase recorded into the JamMan
®
Solo can be played in two ways: either as
a continuous Loop, or as a Single “one-
shot” sample. Single phrases play the
recorded phrase only once and stop. All
phrases are recorded as loops by default
but they can be changed to a Single phrase
if desired. You can always change Single
phrases back to Loops later without
harming the phrase. To change between
Single and Loop, follow these steps:
Stop loop playback if it is playing.1.
Select a previously recorded Loop 2.
phrase (LOOP LED is lit) using the
LOOP SELECT buttons. If the
CARD MEM LED is lit, you have
selected a memory location on the
optional memory card.
Press and hold the 3. TEMPO and
STORE buttons simultaneously to
enter the Setup menu. The LOOP
LED will now be flashing and Lo
(Loop) will shown in the DISPLAY.
Use the 4. LOOP SELECT buttons to
select the SINGLE LED so it begins
flashing (The display will show Si).
If changing from a Single to a Loop
phrase, use the LOOP SELECT
buttons to select the LOOP LED so
it begins flashing. The STORE button
will light to indicate this change must
be stored if it is to be recalled later.
Press the 5. STORE button twice to
store the changes, if desired.
Loop / Single Phrases

DigiTech JamMan Solo Specifications

General

Brand	DigiTech
Model	JamMan Solo
Category	Music Pedal
Language	English