DITEC LCA70 User Manual

12
IP2368EN
EN
9. Using menus
NOTE: pressure on the keys may be quick (less than 2 s) or prolonged (longer than 2
s). Unless specified otherwise, quick pressure is intended. To confirm the setting of a
parameter, prolonged pressing is necessary.
9.1 Switching the display ON and OFF
The procedure to switch on the display is as follows:
• press the key
ENTER
;
• the display functioning check starts ;
• the first level menu is displayed
;
The procedure to switch off the display is as follows:
• press the key
ESC
NOTE: the display switches off automatically after 60 s of inactivity.
9.2 Navigation keys
• UP and DOWN keys: for scrolling through level one or two menus and through the list of possible
values for a specific parameter.
• ENTER key:
accesses the next menu level or the list of possible values for a menu parameter. Press
and hold to confirm selection of the currently displayed parameter value.
• ESC key: go back to previous step in navigation.
• Simultaneous pressing of the keys UP and ENTER performs an opening command.
UP
+
ENTER
→
• Simultaneous pressing of the keys DOWN and ENTER performs a closing command.
DOWN
+
ENTER
→
• Simultaneous pressing of the keys UP and DOWN performs a POWER RESET command. (in-
terruption of the power supply and restart of the automation).
UP
+
DOWN
→
• Hold down the UP or DOWN key to begin fast menu scrolling.
• In some menus, the parameter measurement unit can be viewed by pressing the ENTER key
once the value has been displayed.
Example: setting of 30 seconds for TC parameter.
UP
→ →
ENTER
→ →
ENTER
→
UP
→ →
ENTER
DOWN DOWN
for 2s

DITEC LCA70 Specifications

General

Brand	DITEC
Model	LCA70
Category	Control Panel
Language	English